A driver's day
Sample data — Danny isn't a real driver, and nothing here reaches a real fleet. The camera stays off; tap a truck to simulate the scan.
This is the real app your drivers use, running on a sample fleet. Pick a plan, then walk through a day — scan into the truck, run the pre-trip, clock on, review a coaching clip, and close out at End of Day.
You activate once with the 6-digit code from your fleet. After that you scan the sticker in whichever truck you drive, and you stay signed in through every stop. If your fleet uses key fobs or assigns trucks in MyGeotab, the app shows your truck without a scan. Scanning another truck switches you over.
Every sticker has a 6-character vehicle code under the QR. Tap Enter vehicle code on the Scan screen and type it in.
Your trips come from the truck's Geotab device while you're signed into it. The app stamps time and location when you clock on and off and when you submit an inspection. It doesn't follow you around.
Your fleet's managers see the same numbers you do. Only trips you were signed into count, and events fade as you keep driving clean.
Short dashcam clips your manager chose to share. Watch it, answer a one-tap safety check, and acknowledge — it's added to your training record.
No. Stops at a job site zone show red until they have a Job ID. Gas stops, parts runs and other visits are fine blank. Tap any stop to add or fix a job, name or phase, even after you submit, until your manager approves the day.
It depends on your fleet's plan. Driiver ID is scan & go with your day's trips, miles and drive time. Driiver ID Pro adds pre-trip inspections, vehicle health and your safety score. Time cards and Coaching are add-ons your fleet switches on.
Open driiverapp.com/app on your phone and add it to your home screen. Nothing to download from an app store.